CONSTRUCT THE CIRCUIT ON PAPER BOARD

After finish constructed, I put the component on the stripboard.

CHECK THE RESISTANCE

The resistance for variable resistor is 220k Ohms. At this level, when push the reset button, the yellow LED will automatically on.

CHANGE THE CIRCUIT

Briefing 2 FYP

MEMO

COURSE CODE
- WPD 49806
- NON SLT SYLLABUS
- FOR INTAKE JULY 2010

LOGBOOK/BLOG - 20%
PRODUCT DEMO - 20%
FINAL REPORT     - 20%

PRESENTATION/PRODUCT DEMO - WEEK 14 - THURSDAY
LOGBOOK/BLOG                               - WEEK 15
FINAL REPORT                                    - WEEK 15 (DRAFT)
                                                                - WEEK 17 (HARD COVER)

                                                             

FORMAT OF FYP REPORT

1. COVER - DARK BLUE
2. SPACING - 1.5 LINES
3. FONT - TIMES NEW ROMAN
4. FONT SIZE - 12 POINT
5. LETTERS - CAPITAL

• TITLE - NOT MORE THAN 20 WORDS
• DECLARATION PAGE
• AKNOWLEDGEMENT - SHORT AND SIMPLE
• ABSTRACT - 1 PARAGRAPH: 400 WORDS

 ABSTRACT
- WHAT DID YOU DO
- WHY DO. WHAT QUESTION TRYING TO ANSWER
- HOW DID

REPORT
- INTRODUCTION
- LITERATURE REVIEW
- METHOD
- RESULT AND ANALYSIS
- CONCLUSION AND RECOMMENDATION

PROBLEM STATEMENT
- DESCRIBE THE PROBLEM
- EXPLAIN HOW TO TACKLE THE PROBLEM

LITERATURE REVIEW
- Author, title of reference....

METHOD
- INFORMATION NEEDED TO ANOTHER

RESULT
- ACTUAL STATEMENT OF OBSERVATION
- STATISTIC, TABLE

CONCLUSION
- STRESS OUT THAT IDEA WOULD WORK
- ANY DECISION AND UNDERSTANDING
- RELATE WITH OBJECTIVE AND PROBLEM STATEMENT

BOOK
- AUTHOR
- DATE OF PUBLICATION
- TITLE
- PLACE OF PUBLICATION
- PUBLISHER

JOURNAL
- AUTHOR, DATE, ARTICLE TITLE, JOURNAL TITLE
-------------------------------

Change The Position Of Voltage Supply & GND

Salam

Below is the circuit that I construct. But just two LEDs on.

I try to change the place of voltage supply (+5V) with ground (GND). Then all LEDs on. Why this happen?

Jalan-Jalan To Jalan Pasar

Today I went to Jalan Pasar to buy some components. I went to two shops. Nixie and Caltrus.

COMPONENTS

1) IC LM 3915
2) Resistor - 560 Ohms
                    - 470 Ohms
3) Diode 1N4148
4) Capacitor 100uF
5) 1x40 way pin header
6) 1x16 way fence header

CHECK USING MULTIMETER

Go to the lab

Laboratory

Salam...

Today I went to the laboratory to reconstruct my circuit. But the result is same.

Then I try to change using  the LED's trainer. But I don't know why just red LED is on.

I try again and I saw the 1st green LED is on, followed with 2nd green LED and yellow LED. Then there was smoke at the yellow LED. That's mean the LED is burned and same goes to both green LED.

Luckily the LED's trainer did not affect anything. Pheuw~